Subject: testing my new ignition on my RX8
From: rotaryeng
Date: 1/29/2014, 12:40 PM
To: AAA-rotaryeng

   I took a look at the front of the RX8 engine and I would have to
   take off a lot of stuff to get to the e-shaft and replace the stock
   trigger wheel.

   I decided to use a micro computer to sense the ignition pulse of
   the stock RX8  EFI computer and add multi strike capability. The
   stock RX8 system fires only once around 22 degrees BTDC. My system
   is capable of firing ten times every ten degrees.

   22 deg BTDC, 10 deg BTDC, TDC, 10 deg  after, and 20 deg after etc.
   etc.  up to 160 degrees.

   The micro computer will detect the stock firing and then do the
   firing of my ignition system at the proper following times.

   This will only work correctly at 3000 RPM which the cruising speed
   on the freeway in 6th gear for 80 MPH. The 3000 RPM will be the red
   line for this testing.

   All this is easier than installing a new trigger wheel on the nose of
   the e-shaft while the engine is still in the car.

   I want a back to back fuel consumption test at a steady 80 MPH. My
   ign  system verses the stock ign system.

   I am looking at Picaxe as it is programed in BASIC. I prefer that
   over the Arduino modified C language. I am not fond of the Arduino
   language. Pic BASIC has been around for over 20 years as I recall.

   http://www.picaxe.com/

   These are cheap computers that are real easy to program. About as
   easy as it gets. I'll use one per spark plug.

   A 28X2 is about right. A bit over kill but real cheap.

   Hardware interrupts are necessary and crucial and the picaxe has
   them.

   Interrupts and Multi-Tasking
   ************************************************* setint ...........
   Set the input conditions which cause an interrupt setintflags....
   Specify the events which cause an interrupt restart..........
   Restart a program task resume ........ Resume executing a suspended
   program task suspend ....... Suspend a program task

   I would also make a good fuel injection computer. One per injector.


   Paul Lamar



   uh oh Paul...

   the RX-8 that I have and that I bought for my son both are geared for a
   different engine rpm vs. speed set...  MINE is at 4K rpms at 80 mph.... at
   3000 rpm, I'm actually spot on at 60 mph.   (6th gear)

   Gary Buster
   East Texas


   I'll have to get mine out of the hangar and check again. Might be old age memory
   on my part.  What MPG are you getting at a steady (cruise control) 65 MPH?
   I am getting 25 MPG. Mine is a 2004.

   Paul Lamar

Paul,
If I "P port" my RX7 (91 convertible, manual) would my fuel mileage be hurt as the power will definitely be better? Are there bolt on parts (except for the porting part) to make it all work as I don't have much spare time to reinvent the wheel. The engine is out of the car for rebuild. I know your not a fan of just porting but again, which would help my fuel mileage and reliability while not having to also replace computers/ chips (or do those items remain stock)?
Thomas Phy


P-ports and around town are not the best combination :)

It won't run real smooth until 4000 RPM or so.


Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.