Subject: testing my new ignition on my RX8
From: rotaryeng
Date: 1/29/2014, 1:03 PM
To: AAA-rotaryeng



    I took a look at the front of the RX8 engine and I would
    have to take off a lot of stuff to get to the e-shaft and replace
    the stock trigger wheel.

    I decided to use a micro computer to sense the ignition pulse
    of  the stock RX8  EFI computer and add multi strike
    capability. The stock RX8 system fires only once around 22 degrees
    BTDC. My system is capable of firing ten times every ten degrees.

    22 deg BTDC, 10 deg BTDC, TDC, 10 deg  after, and 20 deg after etc.
    etc.  up to 160 degrees.

    The micro computer will detect the stock firing and then
    do the  firing of my ignition system at the proper following times.

    This will only work correctly at 3000 RPM which the cruising speed
    on the freeway in 6th gear for 80 MPH. The 3000 RPM will be the red line
    for this testing.

    All this is easier than installing a new trigger wheel on the nose of
    the e-shaft while the engine is still in the car.

    I want a back to back fuel consumption test at a steady 80 MPH.
    My ign  system verses the stock ign system.

    I am looking at Picaxe as it is programed in BASIC. I prefer
    that over the Arduino modified C language. I am not fond of the
    Arduino language. Pic BASIC has been around for over 20 years
    as I recall.

    http://www.picaxe.com/

    These are cheap computers that are real easy to program.
    About as easy as it gets. I'll use one per spark plug.

    A 28X2 is about right. A bit over kill but real cheap.

    Hardware interrupts are necessary and crucial and the picaxe has
    them.

    Interrupts and Multi-Tasking
    *************************************************
    setint ........... Set the input conditions which cause an interrupt
    setintflags.... Specify the events which cause an interrupt
    restart.......... Restart a program task
    resume ........ Resume executing a suspended program task
    suspend ....... Suspend a program task

    I would also make a good fuel injection computer. One per injector.


    Paul Lamar

    --

    Paul,
    How difficult would it be to install on my EP car?

    David Smith


I am not ready to ship. Still getting the bugs. I just failed a HV coil.

Probably about the same..... as you will have to remove all the rads.
I am going to use OBD II software to make the measurements.
It is hard to detect any improvements with out extensive sensors
and recording devices.

OBD II has all that built in.

Here are some pictures of Dave's racer.

How did you do at Sebring?

Paul Lamar

      The Rotary Engine News Letter. Powered by Linux.
      ACRE NL web site. http://www.rotaryeng.net
      You Tube http://tinyurl.com/beqqxas
      Copyright 1998-2013 All world wide rights reserved.