I took a look at the front of the RX8 engine and I would have to take
off a lot of stuff to get to the e-shaft and replace the stock
trigger wheel.
I decided to use a micro computer to sense the ignition pulse of the
stock RX8 EFI computer and add multi strike capability. The stock
RX8 system fires only once around 22 degrees BTDC. My system is
capable of firing ten times every ten degrees.
22 deg BTDC, 10 deg BTDC, TDC, 10 deg after, and 20 deg after etc.
etc. up to 160 degrees.
The micro computer will detect the stock firing and then do the
firing of my ignition system at the proper following times.
This will only work correctly at 3000 RPM which the cruising speed on
the freeway in 6th gear for 80 MPH. The 3000 RPM will be the red
line for this testing.
All this is easier than installing a new trigger wheel on the nose
of the e-shaft while the engine is still in the car.
I want a back to back fuel consumption test at a steady 80 MPH. My
ign system verses the stock ign system.
I am looking at Picaxe as it is programed in BASIC. I prefer that
over the Arduino modified C language. I am not fond of the Arduino
language. Pic BASIC has been around for over 20 years as I recall.
http://www.picaxe.com/
These are cheap computers that are real easy to program. About as
easy as it gets. I'll use one per spark plug.
A 28X2 is about right. A bit over kill but real cheap.
Hardware interrupts are necessary and crucial and the picaxe has
them.
Interrupts and Multi-Tasking
************************************************* setint ...........
Set the input conditions which cause an interrupt setintflags....
Specify the events which cause an interrupt restart.......... Restart
a program task resume ........ Resume executing a suspended program
task suspend ....... Suspend a program task
I would also make a good fuel injection computer. One per injector.
Paul Lamar
Paul,
I would like to see something combining electronic ignition and
multi-point electronic fuel injection with redundancy for a FEDAC system
for aircraft. Doesn't hurt to dream. Thanks for your items you pass
along. We don't end up reinventing the wheel when we can see what has
already been thought about and maybe we can avoid repeating mistakes
made before. Keep up the good work.
Gary
Not what I am working on. If you are bucks up Motec is the way to go.
Also check out Microtech in Oz.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net.
You Tube
http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.