Hi Paul,

                Well I finally did it and turned off those teeth, boy that is good steel, I had to use my Tungsten carbide tip to cut it. I was thinking of using those machined grooves and making up matching grooves on the prop shaft flange to carry woodruff type keys to take the drive, I would probably make another 3 grooves as well. Bolt the flange on to the planet carrier as discussed but without the hollow dowels.

                                Chris.


Nice work Chris. I am jealous of your lathe :)
Good pictures too.


Paul Lamar



 The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2013 All world wide rights reserved.