Subject: jump T/O gyro
From: rotaryeng
Date: 2/13/2014, 11:18 PM
To: AAA-rotaryeng


I have been working on a jump T/O gyro for some time, we used a
laminated steel hub bar so it could be twisted for pitch change
using a geared electric motor fed by slip rings. It seems that while
it is not legal to change pitch in flight, it is legal to change
pitch for flight.

We have had numerous gearbox failures as the drive to the rotor goes
up to direct drive the rotor, we calculate it needs about 12 hp, I
think that is about 120 foot pounds. If I ever get back to that
project I will try an outboard motor gearbox. I have a warning on
the panel: PITCH CHANGE IN FLIGHT MAY  VIOLATE REGULATIONS

John Evans


sounds like a great idea.  Instead of a motor for the pitch horn, a
magnet as those in the electric door locks might work just as well
but much cheaper.  I did the lock on my front gate and found you can
get thousands of pounds of force out of a few micro amperes of
current depending on the number of rounds on the coil.  A small
battery will do it.

Could you send a picture of your rotor head?

Gordon Gao



OK Gordon, but it will take time as I am in hospital with a new right
shoulder joint.

I will post when I am at our skunkworks next, it could be a month.

John Evans

-- 

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.