I looked and looked and could not find anybody willing to
        wind my ignition coils. Probably most are made in china or
        with automation.

        A coil winder that would do what I need done is several thousand
        dollars.

        I had to invent my own.

        Can anybody tell me what it has in common with the Wright brothers
        flyer ? :)

        Paul Lamar

    How about using a fishing reel with the mechanism to wind the line back and forth.
    Just modify it to be able to remove the end opposite the crank. Could drive it with a
    drill and use a micro switch to turn it off when the required diameter (number of turns)
    is reached.

    Dale Davies

    I have never gone fishing :) They are costly are they not?


    The bearing plates are done with the bearings pressed in.


    Paul Lamar

The m/n 209 is the one I was thinking of.

Dale Davies

It must stop between layers to add special HV insulating tape.

Almost done.

Paul Lamar

        The Rotary Engine News Letter. Powered by Linux.
        ACRE NL web site. http://www.rotaryeng.net.
        You Tube http://tinyurl.com/beqqxas.
        Copyright 1998-2013 All world wide rights reserved.