I looked and looked and could not find anybody willing to wind my
ignition coils. Probably most are made in china or with automation.

A coil winder that would do what I need done is several thousand
dollars.

I had to invent my own.

Can anybody tell me what it has in common with the Wright brothers
flyer ? :)

Paul Lamar

How about using a fishing reel with the mechanism to wind the line
back and forth. Just modify it to be able to remove the end opposite
the crank. Could drive it with a drill and use a micro switch to turn
it off when the required diameter (number of turns) is reached.

Dale Davies

I have never gone fishing :) They are costly are they not?


The bearing plates are done with the bearings pressed in.

Paul Lamar


Paul, That crossed belt would wear out in a flash would it not ? the
fishing reel idea is a stoke of genius apart from having to dismantle
it to change reels, the front loader type of reel would be ideal
though. Chris.


The RPM is rather low and they are cheap O-rings 10 to a McMaster
pack.

Paul Lamar


Or, you could replace it with two inter-meshed spur gears.  The output
will still go in the same directions.

 Mark LaPierre


I don't want it to go in the same direction :)
That is a lot more work and cost anyway.

Paul Lamar