Paul been thinking for years about your concept of the 50 MPH Rx8,
I had a similar idea for the Wankel Engine, but using that unique output
shaft with a hole drilled through it, as you have shown. I thought to
make light weight helicopter drive for the tail rotor, using exhaust
effluent combination to drive the tail rotor shaft. The main reason I
was seeking this type of solution was to make power out landings with a
helicopter safer with a wankel rotary engine (less hardware hanging on
main rotor gears means potential for higher Main Rotor speed), since
converting to Auto Rotation is your life saving procedure.
I digest, back to my question, Paul can the exhaust from the small
one rotor be directed to the main two rotor engine and achieve some
boost to hp. Secondary, can that effluent be re-ignited in a reduced
capacity to produce more hp ? I consider this a sort of reduced
efficiency turbo compounding idea, but could it work ?
My goal is to achieve 50 MPH Rx8 design, and ultimately reduce
import oil from overseas suppliers with interests not hostile to free
manufacturing nations of the world. If as you say this can be done with
only 50 lbs of weight, then the piping to connect exhaust to the main
rotary engine would be very light weight also.
As you state a Aixro Kart Engine would be a nice proof of concept
method, to build out a test system. Exhaust Piping and secondary burn
main engine firing could be cost effective.
In reply Paul states that "you want O2 and not CO2 to get more
power :)"
"Yes you can get more power for the turbine but you need to get medium
pressure air (O2) into the exhaust system which implies a hp
sucking air pump."
Sorry Paul, was typing and not reviewing words, when I thought
re-ignition, my thought was to add O2 to main rotary engine hoping to
fire the exhaust flow of the small single rotary engine as defined on
rotaryeng.net
<http://rotaryeng.net>, adding O2 using remaining fuel
content or even adding some fuel to be ignited for additional hp output.
http://www.rotaryeng.net/RX8-TC-eng3.html
<http://www.rotaryeng.net/RX8-TC-eng3.html>
George Curtis
Just the fact that you can cruise on the small engine
increases the MPG because you are in a better place on
the BSFC map.
In other words the best BSFC island
moves down towards the road load curve.
That is why a Corvette is doing 80 MPH at less than 2000 RPM.
Latest idea is to bolt an AIXRO engine onto
the RX8 differential housing.
Pure mechanical hybrid.
Paul Lamar
Opps forgot the pictures.
Here they are.
P
Paul,
Another thought, could the Main two Rotary Engine in the 50 MPG Rx8 have
water injection to the rotors. I read some where that how old steam
engines worked was that super heated steam has a volume 1800 times its
original volume. Would the waste heat from the small rotary engine be
enough to create additional hp to the main rotary engine, and would that
injection damage or impair resumption of normal function of the main
rotary engine ???
Sort of creating a hybrid rotary engine, think I saw a few years ago one
of the major European Manufacturer's proposing an exhaust system to do
water injection !!!
George Curtis
That is the six cycle. Two injections of gasoline and one of water.
Lots of problems but pure water is more expensive than gasoline :)
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net.
You Tube
http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.