Hi all,
Hope you like the photo this is about the shape I want to put into my
helicopter
I have drawings(incomplete) of the Scorpion Too rotor hub and swash
plate should anyone want a copy please PM me and I will send.
I am working on engineering drawings of the Rotorway 162F which is a
much improved system.
The system from the controls up is less complex also working on drawings
of double reduction gearbox.
While I think the worm and wheel may be good it doesn't work with a
vertical engine and gets away from my original intention.
It would put the engine off center. But would be good where the twin
engine would be used, the question would be how much torque will it
withstand.
I had a look at a D2 Helicopter the other day, I am told that this beast
cost a fortune to build the gearbox designed by local engineer is 18KG
(40Lbs) and using a diesel 2stroke engine and the guy asked why I was
using a rotary I believe with the fully articulated rotor head it just
about shook its self to piece and lifted the right skid off the ground.
I think I could fix this with a three rotor rotary engine plenty of
power a good balance( hang it up on a crane) , two blades or 3 fixed
blades and probably with the 18KG gearbox in situ the cabin is built
very strongly, just needs the power to lift it, their diesel only came
in at 190hp.
My Scorp rotary turbo will be 500hp and is a lot lighter, for a full
grown helicopter the D2 would be good.
Regards
George Crooks Aus
I would like the dwgs.
You don't want to mount the rotary engine vertically.
The essential cooling oil drain back from the rotors would not
work. It should be mounted horizontal and upright as it is in a car.
You can get away with it in a piston engine but not in a rotary.
That is another advantage of the worm drive. It turns the rotary motion
90 degrees. You can mount the single engine at a slight angle looking
down on it
to adjust the CG. Power for the tail rotor can come back from a shaft under
the engine.
Paul Lamar