Subject: New 3 rotor helicopter design
From: rotaryeng
Date: 2/18/2014, 8:06 AM
To: AAA-rotaryeng



Hi all,

Hope you like the photo this is about the shape I want to put into my helicopter

I have drawings(incomplete) of the Scorpion Too rotor hub and swash plate should anyone want a copy please PM me and I will send.

I am working on engineering drawings of the Rotorway 162F which is a much improved system.

The system from the controls up is less complex also working on drawings of double reduction gearbox.

While I think the worm and wheel may be good it doesn't work with a vertical engine and gets away from my original intention.

It would put the engine off center. But would be good where the twin engine would be used, the question would be how much torque will it withstand.

I had a look at a D2 Helicopter the other day, I am told that this beast cost a fortune to build the gearbox designed by local engineer is 18KG
(40Lbs) and using a diesel 2stroke engine and the guy asked why I was using a rotary I believe with the fully articulated rotor head it just about shook its self to piece and lifted the right skid off the ground.

I think I could fix this with a three rotor rotary engine plenty of power a good balance( hang it up on a crane) , two blades or 3 fixed blades and probably with the 18KG gearbox in situ the cabin is built very strongly, just needs the power to lift it, their diesel only came in at 190hp.
My Scorp rotary turbo  will be 500hp and is a lot lighter, for a full grown helicopter the D2 would be good.

Regards
George  Crooks Aus

I would like the dwgs.

You don't want to mount the rotary engine vertically.

The essential cooling oil drain back from the rotors would not work. It should be mounted horizontal and upright as it is in a car.

You can get away with it in a piston engine but not in a rotary.

That is another  advantage of the worm drive. It turns the rotary motion
90 degrees. You can mount the single engine at a slight angle looking down on it to adjust the CG.  Power for the tail rotor can come back from a shaft under the engine.


Paul Lamar

Hi Paul,

Which drawings is it you would like is that the Scorpion TOO rotor Hub?

Regarding the oil cooling for the rotors Im very interested to follow this up before I commit to a path.

Best to get these things sorted before problems are created

Do you have a drawing of the rotor oil cooling

Regards
George from AUS

Here is some info on rotor cooling.

Send me what dwgs you have.

Paul Lamar

-- 

 The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2014 All world wide rights reserved.