Subject: New 3 rotor helicopter design
From: rotaryeng
Date: 2/18/2014, 3:26 PM
To: AAA-rotaryeng


Hi all,

Hope you like the photo this is about the shape I want to put into my
 helicopter

I have drawings(incomplete) of the Scorpion Too rotor hub and swash
plate should anyone want a copy please PM me and I will send.

I am working on engineering drawings of the Rotorway 162F which is a
 much improved system.

The system from the controls up is less complex also working on
drawings of double reduction gearbox.

While I think the worm and wheel may be good it doesn't work with a
vertical engine and gets away from my original intention.

It would put the engine off center. But would be good where the twin
 engine would be used, the question would be how much torque will it
 withstand.

I had a look at a D2 Helicopter the other day, I am told that this
beast cost a fortune to build the gearbox designed by local engineer
is 18KG (40Lbs) and using a diesel 2stroke engine and the guy asked
why I was using a rotary I believe with the fully articulated rotor
head it just about shook its self to piece and lifted the right skid
off the ground.

I think I could fix this with a three rotor rotary engine plenty of
power a good balance( hang it up on a crane) , two blades or 3 fixed
 blades and probably with the 18KG gearbox in situ the cabin is built
 very strongly, just needs the power to lift it, their diesel only
came in at 190hp. My Scorp rotary turbo  will be 500hp and is a lot
lighter, for a full grown helicopter the D2 would be good.

Regards George  Crooks Aus

I would like the dwgs.

You don't want to mount the rotary engine vertically.

The essential cooling oil drain back from the rotors would not work.
It should be mounted horizontal and upright as it is in a car.

You can get away with it in a piston engine but not in a rotary.


That is another  advantage of the worm drive. It turns the rotary
motion 90 degrees. You can mount the single engine at a slight angle
looking down on it to adjust the CG.  Power for the tail rotor can
come back from a shaft under the engine.


Paul Lamar



Please ensure that your worm drive can tolerate the expected torque, one of my early gearbox failures was a worm drive that looked substantial, but the worm flexed and jumped over the teeth on the worm wheel. Obviously the length and stiffness of the worm are of great importance if it is to handle much torque. A suitable gearbox may be quite massive.

John Evans


Of course :)

Make sure the pinion shaft is of sufficient diameter as the stiffness goes
up with the cube of the diameter and the pinion is supported on both
ends with bearings. Use oil pressure fed plain bearings to keep the weight
down and handle the RPM of a rotary.  The rotor shaft can use needle bearings
as the RPM is low.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2014 All world wide rights reserved.