Subject: Mazda RX8 coil connectors
From: rotaryeng
Date: 2/21/2014, 8:54 PM
To: AAA-rotaryeng



   I checked with a Mazda dealer and they want over $1000 for a
   complete engine harness.

   They don't sell just the connectors.

   Does anybody know where I can buy just RX8 coil connectors?

   I am making one out of a nylon block and molex round socket
   connectors but this is less than ideal.

   I am going to put the scope on the coil and check the dwell with the
   engine running.

   Paul Lamar

   Try Digikey or do a google search for after market and racing car
   wiring harness suppliers.

   chris smale


   what search words did you use in DigiKey ?

   They have 1000's. I tried a few like "Mazda spark coil connectors."
   No luck. If they are there I have no idea where to look.

   Paul Lamar


   I found some connectors for my project by thumbing through the catalog.
   chris smale


The simple way to tap into the electronics wiring is to get a package of T pins
or the long (2 1/2¨ or 3¨) pins with the plastic ball on the end. These can be inserted
between the wire and the seal without damaging the seal. When fully inserted
they contact the metal terminal and you can then read what is going on in
operation. You just have to ensure the wires or pins with volts can not come in
contact with a ground pin if that is what you have. Sometimes it is good to have the
meter ground right on the battery. Also verify ECM ground is the same potential as
the negative battery post. Your wife may have these pins in a sewing kit.

Dale Davies



-- 

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.