Hi Paul,
I found this comment on
www.rotaryforum.com <http://www.rotaryforum.com>
site and would be very interested in your opinion.
Engine is a heat generator, my exhaust was 2 1/2 stainless tube, can't
remember alloy right off hand, stood up well.
Yes it was hot, neighbors would tell me it was so white they could see
through it.
Tubes went into a can aprox. 12” long by 10” dia. this can was key to
quieting down the noise, then to a muffler.
The can is what they used in the day to super tune off road motor cycles
only much-much smaller.
Lot of time put in to finding this to quieting down without losing power.
Both exhausts appear to be manufactured in similar styles
Wondering if this is some sort of phenomena or normal for rotary engines,
Does the exhaust configuration need changing to get a better result
There has been no mention of engine overheating, just the exhaust
glowing white hot
Do you think the engine could be running lean.
I have no information on the engine carburettor, injected turbo or not
The guy doesn’t answer much on the site.
If anyone has any suggestions especially about designing exhaust systems
or what works best I would be grateful.
Kind regards
George
It is quite normal for the rotary and that is one of the reasons it
would make a good turbo compound engine.
All engines reject a lot of heat to the exhaust but piston
engines have exhaust valves that absorb some of the heat.
The Wankel varies only slightly but it has no exhaust valves.
It is called heat balance.
Contact Neal Ungar for one of my How to Cool Your Wankel books in Aus.
They are also now available in Germany from:
Poul Henrik Woelfle AIXRO
<ph.woelfle@woelfle-engineering.com>
Mario Haeberer2 Wankel-AG
<mail@wankel-ag.de>
Next time Henry comes home I will give him some for China and
Hong Kong.
The coax muffler designed would work for a helicopter if you could
route some of the down wash to the slipstream air intake.
Paul Lamar