Paul,



I have been looking at ways to keep the stock 2ndgen CAS for future modifications like ignition system upgrade.

At present Tracy set up the EC-4 to use the RX-8 trigger wheel.  The 2^nd gen CAS unit hits the V belt and augmenter tube.

I even tried to cut the housing down and perhaps design a low profile cover so the belt would clear and the augmenter would clear.  I think the only way that will happen is if I eliminate the hall sensor for the 2 tooth wheel and keep the lower wheel.  At least I would have a source for your tach circuit.  Using the fly wheel would put the frequency way out of the range of the tach circuit.



Joe Berki


Here is my new trigger wheel. I am getting it ready for a Lamar ignition demo at Sun N Fun in 2 weeks.
I will also work with the RX8 CAS. Fires at 20 deg BTC and 4 or 5 times after that
every 10 degrees of e-shaft rotation.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2014 All world wide rights reserved.