Got the inter-cooler and plate

the good news is the inter-cooler will work

The bad news a couple of hours will be required just to get
all the old stuff off it :)


If you want me to build the rubber bushing holders
you can save money by gathering all the required bits and
pieces and mailing by PO no sig required :)

Six inches of 2 inch .062 wall 4103 tube
some 4130 bar stock .062 thick

and some large  2 inch OD fender washers



Paul

On 04/16/2014 09:24 AM, Collier, Michael D wrote:

-----Original Message-----
From: rotaryeng [mailto:rotaryeng@earthlink.net]
Sent: Wednesday, April 16, 2014 9:01 AM
To: Collier, Michael D
Subject: PRIVATE Mike Collier Turbo Long EZ

Make up a couple of rubber bushing holders out of .065 4130

The NC machined versions you can sell.

Paul

Rather than butcher and tig weld on additions to your existing plate I can make a new one quicker and cheaper.

Industrials Metals will saw it out of 1/2 inch thick 6061T6  at low cost.
I can match drill most of the holes and bore a couple for the seals and the starter pilot.

You can put your plate up for sale for some one building a front engine airplane.

for got the attachment

BTW it is at the PO

Paul

Ok Paul, I can offer my old plate up to the group and see if anyone can use it.  Let me know how much you need to get the work done and I'll send you some $$$.  Thanks again for your help

Mike C