Hello Mr Paul Lamar. I want some information about oil property (and
also the oil already use ) for aircrat rotary engine. in google I do
not find something and in a website I see your newsletter. please
help me if you can Thank you Mahdi Barjasteh
For the oil sump we recommend Mobil 1 or Idemitsu rotary engine oil.
For the apex seals we recommend mixing one ounce of two cycle oil
with each gallon of gasoline.
4 liters is about one gallon US so 1 ounce liquid US is about 30 cc
in the French system :)
30/4 is 7.5 so 7.5 cc per liter will work fine.
Paul Lamar
I'd say that an additional possibility exists of putting 1 cc of
LiquiMoly (MoS2) for every liter of fuel, that's what the producers
of this Molybdenum Di-sulphide say, and the attached chart from the
book by E McGovern points to a reduced wear when leaded gasoline was
employed, Lead acting as a solid lubricant, MoS2 is also a solid
lubricant, and thus, same good results can be expected with MoS2
additives, LiquiMoly or Molykote, as those detected with the
fortunately no longer existent leaded gasolines. Best regards.
Salut † Jose Gros-Aymerich Madrid, Spain
I am not rich enough by a factor of 10 million to try a new apex seal
lubrication. I would have to be near unconscious to try something
that dumb :)
2.5 million Mazda engines have been sold using oil to lube the apex
seals.
IT IS NOT BROKE!!!!!!!! However YOU are free to try it. Let us know
how it works.
Paul Lamar
The proposal I reported is not substituting Solid Lubricants for
common Oil,
but /adding /a Solid Lubricant to the oil/gasoline mix, or just
directly to the
oil, as is done with MoS2 products in 4-Stroke reciprocating engines.
I read long ago some reports of reciprocating engines having run
without
problems for a while after all oil in crankcase was lost, thanks to
having had
a tube of Molykote added to engine Oil after the previous Oil exchange.
(Engine must be started right after putting additive in Oil
replenishing tube, and
run for at least 30 min under real traffic conditions, some advised
not to start
adding MoS2 additives until the 1000 miles run-in period ended).
The amount of LiquiMoly MoS2 additive to be added to Gasoline, it
differs
from an Oil-cooled Rotor Wankel RCE to Charge-cooled Rotor RCEs, comes
from the official suggestions of this German MoS2 producer.
They report no data about the possibility or incidence of Plug fooling
from the additive. Molykote was a trade mark by Dow-Corning.
There was at least a SAE paper or technical publication that reported
small flat holes in the housing's inner surface filled with MoS2 or
other
solid lubricant to improve Wankel resistance to wear, and you know,
MoS2 is part of the lubrication in many turning parts today, some of
it in a non-serviceable or no service needed basis.
Sorry for not having stated the subject clearly from the start.
Have a good weekend. Best regards. Salud †
Jose Gros-Aymerich
Madrid, Spain
Same situation. I have no idea what happens when that stuff burns.
I am not going to risk an engine and wait ten years to see how it
works. Rotor housing and apex seal wear is not a problem in Mazda engines.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net. You Tube
http://tinyurl.com/beqqxas.
Copyright 1998-2014 All world wide rights reserved.