Subject: Patent is now pending on new rotary ignition
From: rotaryeng
Date: 4/29/2014, 6:52 AM
To: AAA-rotaryeng


 As of Friday afternoon.

 I am buying parts for 100 coil on plug units to be used for testing
 by Mazda (hopefully) and others.

 Will fire six times or more around TDC at 11,000 RPM.

 If somebody wants one or more for testing let me know.

 Paul Lamar.... Still in Virgina

 If all goes as planned be back in SOCAL Sunday night.

 Fantastic Paul, Milo



 Can I trigger them with the older crank angle sensor?

 Lewis Bjorkacro


 You can but you will only get two sparks close together on the
 front rotor. I take it this is the one you are talking about. A
 simple circuit could be built to use the lower part and count
 pulses.

 Best to take it out and save the weight. ABS wheel speed sensors
 are cheap and two are required for a two rotor. Or you can use 3rd
 gen or RX8 sensors. You can also make your own as all they are is a
 bar magnet with a coil of wire wound around it.

 This ignition system can also be triggered directly by a computer
 but it must be reprogrammed to eliminate the dwell time and enable
 multiple sparks.

 Paul Lamar   Back in SZP


 I'd like two for my single rotor.  Tell me how much $ and
 when/where.

 Lewis.


 In about 2 weeks. Introductory price is $175 each plus shipping.

 Paul Lamar

 Paul, one per plug, or one per rotor?

 Kevin Alderman

 One per plug. That is a standard in the auto industry now.

    Also the rotary racers use one MSD system per plug but one would also have to buy
    and old style coil one per plug for another $50 or so.

    The MSD stops multi-firing at 4500 RPM. The multi-firing it does do at low
    RPM is all grouped around 20 deg BTDC within a few usec.


 Paul Lamar

I was trying to get a handle on using this system with the EFI that I am working on for my engine. 4 units means 4 triggers from the ECU, which means 4 output pins and at least 2 input for the crank triggers, which would eliminate the need for delay calculations.
Right now I have 2 HE inputs and 2 trigger outputs for the coils that I have and some code for dwell. I can eliminate the dwell part, but this would mean a partial re-write of my code :).  With the leading and trailing plugs, it might be beneficial to fire the plugs at slightly different times to push the flame front around. I would go ahead and write the code to allow for this if necessary.

Kevin Alderman

If you trigger both upper and lower plugs at the same time you only need two outputs
and two inputs. With one input you would need to calculate the second rotor trigger
time based on RPM. That is the beauty of the second CAS signal.

The RX8 trigger wheel gets crank angle and TDC signals with one CAS.
There is a missing pulse detector for rotor 1 TDC IMHO and the second rotor TDC.
That complicates the software.

I have never fed an RX8 signal into an off the shelf reluctance sensor.
I suspect it would not work. Attached is the CD4049 circuit I used
to take the scope pictures.


The third gen uses two CAS's.

The second gen also does this with two CAS's as well.

In 15 years we have tried almost everything :)

Paul Lamar

 The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
 http://www.rotaryeng.net. You Tube http://tinyurl.com/beqqxas.
 Copyright 1998-2014 All world wide rights reserved.