This exceeded my wildest expectations.
It is strong and hard. It cures at modest temperatures.


Here is the Teflon mold and the prototype part that came out of the
mold. It was easy to get it out.

I'll make the legs a bit longer.

The electtronics will be embedded in the plastic.

It could be mounted on my patented beam or on the engine
front cover. One of the many advantage of the beam is the timing is
adjustable. For lowest fuel burn at altitude one would want to adjust
the timing to about 50 degrees BTDC.

This calls for celebration. I'll have ice cream and cake
after dinnertonight :)

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2014 All world wide rights reserved.