If you firing a rotary engine six times every 10 degrees at 10,000 RPM you
need a fast crank angle sensor.
This has a rise and fall times of about 20 nano seconds. A nanosec
is one one thousandth of a micro second. Of course everybody knows
a micro second is one one millionth of a second.
Consequently a nano second is a short period of time to say the least.
Naturally I am very pleased with this device. It is molded plastic
and strong as brick. I'll be sending it off on Monday to Poul
Woelfle in Germany so he can mount it on the e-shaft of an AIXRO kart
rotary for testing our new patent pending high speed CD ignition
in a week or two.
It has the promise of reducing the fuel consumption, increasing
the power, reducing hydro carbon emissions and curing an occasional
mis-fire at idle due to port overlap. It is six times more likely
to fire a bad mixture.
The pulse width shown is about one millisecond and the pulse
amplitude is zero to 12 volts. A very solid and unambiguous signal.
Paul Lamar
Paul,
In regards to firing the plugs six times per
cycle; with all due respect, that may be
over-kill on our engines with the plugs
stacked vertically. On the other hand, if
you fired the plugs three times; first, when
the leading apex seal clears the lower plug,
second, when the rotor is at top dead center,
and last, just before the trailing apex seal
reaches the top plug. You will get your six
sparks all across the rotor face with only
three firings. Now on those engines that
have the plugs side by side, six firings per
cycle would be needed. What do you think.
Frank Clementi
I agree. However if you replace my trigger device with a computer there
are many variations possible. I am not in position to do the R&D on that
as I do not have a dyno. Something Mazda should do.
It may turn out there is an optimum pattern for different RPM's and loads.
One might also find it is best to have all the sparks up front.
The ignition system itself is very flexible and will fire any number of
times
with a wide variation in timing.
You can however make a new disk with holes at different e-shaft angles
if you
feel that is the optimum configuration.
Six at 10 degrees is my wild ass guess for a good starting point.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.