If you firing a rotary engine six times every 10 degrees at 10,000
RPM you need a fast crank angle sensor.
This has a rise and fall times of about 20 nano seconds. A nanosec is
one one thousandth of a micro second. Of course everybody knows a
micro second is one one millionth of a second.
Consequently a nano second is a short period of time to say the
least.
Naturally I am very pleased with this device. It is molded plastic
and strong as brick. I'll be sending it off on Monday to Poul
Woelflein Germany so he can mount it on the e-shaft of an AIXRO kart
rotary for testing our new patent pending high speed CD ignition in
a week or two.
It has the promise of reducing the fuel consumption, increasing the
power, reducing hydro carbon emissions and curing an occasional
mis-fire at idle due to port overlap. It is six times more likely to
fire a bad mixture.
The pulse width shown is about one millisecond and the pulse
amplitude is zero to 12 volts. A very solid and unambiguous signal.
Paul Lamar
Hi Paul, The ignition looks very good. Could you mention my name
to Poul. I am gathering info for a magazine article and may need some
information from him. Any news on Austro Engines new 80 hp rotary. There
was a bit of info at the beginning of the year but now, nothing.
Murry
I think they may have ran into problems. I suspect they underestimated
the torque
pulse from a one rotor that large. I don't really know. Seemed like a
good idea at the time. I think they would be better off with a turbo as
their
main customer is Alexander Schleicher sail planes, the worlds largest
user of rotary engines in aircraft not counting UAV's.
Ignition of gasoline depends on the spark being immersed in a mixture in
the
air fuel range of 10:1 to 20:1. The mixture ratio varies widely in the
combustion
chamber and it is very turbulent meaning that any given moment the mixture
may or may not not be ignitable. Due to port overlap some exhaust gases
(less oxygen) could be included making the mixture non ignitable at a
given moment in time.
That is what happens in the old Mazda 13B and causes
a distinctive and noticeable miss at idle.
The RX8 eliminated the port overlap for that reason.
This ignition is six times more likely to find an ignitable mixture ratio
because it waits for a good mixture to come along :) Notice the Wankel
combustion stroke lasts almost 300 degrees while the piston combustion
stroke is only about 120 degrees. During this long time period some
un-combusted
combustible mixture may be passing the spark plug. We know this is
the case because of the high hydro carbon content in the Wankel exhaust.
Our goal is to ignite that mixture thereby gaining a lower BSFC and
more power.
It is well known that a hotter spark can ignite a lean mixture better.
The best MPG in an aircraft engine is obtained with a lean mixture
in the vicinity of 18:1 and with a spark advance of 50 degrees
or so at low manifold pressures (high altitude).
I am counting on that happening with this ignition.
Klaus tells me a good ignition can set paper on fire. Mine has no trouble
doing that :)
Paul Lamar
The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.