If you firing a rotary engine six times every 10 degrees at 10,000
RPM you need a fast crank angle sensor.
It has the promise of reducing the fuel consumption, increasing the
power, reducing hydro carbon emissions and curing an occasional
mis-fire at idle due to port overlap. It is six times more likely to
fire a bad mixture.
Paul Lamar
Ignition of gasoline depends on the spark being immersed in a mixture in
the air fuel range of 10:1 to 20:1. The mixture ratio varies widely in the
combustion chamber and it is very turbulent
meaning that any given moment the mixture
may or may not not be ignitable. Due to port overlap some exhaust gases
(less oxygen) could be included making the mixture non ignitable at a
given moment in time.
That is what happens in the old Mazda 13B and causes
a distinctive and noticeable miss at idle.
The RX8 eliminated the port overlap for that reason.
This ignition is six times more likely to find an ignitable mixture ratio
because it waits for a good mixture to come along :) Notice the Wankel
combustion stroke lasts almost 300 degrees while the piston combustion
stroke is only about 120 degrees. During this long time period some
un-combusted combustible mixture may be
passing the spark plug.
We know this to be a fact because of the high hydro carbon
content in the Wankel exhaust. Our goal is to ignite that mixture
thereby gaining a lower BSFC number and more power.
Paul Lamar
I just had another idea along these lines. If the mixture is too rich to
ignite
a very small quantity of high pressure fresh air injected close to the spark
around TDC would help. The amount and duration could be determined by
experiment. Here are some 3D's. NOS or hydrogen could also be
used but air is cheaper :)
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.