Subject: high speed CD ignition with air injection.
From: rotaryeng
Date: 6/13/2014, 9:30 PM
To: AAA-rotaryeng



If you firing a rotary engine six times every 10 degrees at 10,000
RPM you need a fast crank angle sensor.

It has the promise of reducing the fuel consumption, increasing the
power, reducing hydro carbon emissions and curing an occasional
mis-fire at idle due to port overlap. It is six times more likely to
fire a bad mixture.


Paul Lamar

Ignition of gasoline depends on the spark being immersed in a
mixture in the air fuel range of 10:1 to 20:1. The mixture ratio
varies widely in the combustion chamber and it is very turbulent
meaning that any given moment the mixture may or may not not be
ignitable. Due to port overlap some exhaust gases (less oxygen) could
be included making the mixture non ignitable at a given moment in
time.

That is what happens in the old Mazda 13B and causes a distinctive
and noticeable miss at idle. The RX8 eliminated the port overlap for
that reason.

This ignition is six times more likely to find an ignitable mixture
ratio because it waits for a good mixture to come along :) Notice
the Wankel combustion stroke lasts almost 300 degrees while the
piston combustion stroke is only about 120 degrees. During this long
time period some un-combusted combustible mixture may be passing the
spark plug.

We know this to be a fact because of the high hydro carbon content
in the Wankel exhaust. Our goal is to ignite that mixture thereby
gaining a lower BSFC number and more power.


Paul Lamar

I just had another idea along these lines. If the mixture is too
rich to ignite a very small quantity of high pressure fresh air
injected close to the spark around TDC would help. The amount and
duration could be determined by experiment. Here are some 3D's. NOS
or hydrogen  could also be used but air is cheaper :)

Paul Lamar

A very good idea, this new approach to Stratified Charge RCEs! Now
that electronics, EFI and electromechanical devices have prices lower
that going out for dinner, the number of ways for improving all
issues formerly problematic in Wankel engines grows exponentially
year after year. Please keep us aware of results!

Best regards. Salut †         Jose Gros-Aymerich; Madrid, Spain

Hi, the Orbital Fuel injection uses dual injectors: one to meter the
fuel
and another for the compressed air blast to inject it into the cylinder.
Mercury Optimax outboards are one application.  Originally designed for two
strokes, it works great on four strokes.
I do not know if it has been tried on a rotary.  It should work.
They
seem to like to have the spark plug electrodes out in the edges of the
fuel/air plume.  That could be a problem with the rotary.  It is more
expensive than single fluid injection.


Murry I. Rozansky

The difference is the quantity of high pressure air. Small quantity
low compressor HP consumption. We need just enough to ignite
the rich mixture around the spark gap only.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.