Subject: Fwd: Re: Help with Tracy EFI.
From: rotaryeng
Date: 6/14/2014, 6:04 PM
To: AAA-rotaryeng



I took Tracy's EFI out of Mike Wills RV4 and can't get it to work on
the bench. It is getting a good CASsignal as I have a drill motor
driven 2nd gen CAS. It was working in the airplane.

I would be nice if Tracy had put a couple of LED's here and there to
reassure something was working.

If I ever design and build and EFI I will surely do that because it
is real cheap.

I am open to suggestions. I checked the wires and they seem OK

Will it work with out the PCM connected?

The relay works that selects one of the two computers.


I want to measure the dwell period  Tracy choose.

Paul Lamar



Paul,

What kind of voltage are you getting out of the CAS?

Joe Berki

At low RPM it is about 5 volts. The higher the RPM the higher
voltage. Typical of variable reluctance sensors. Tracy uses this zero
crossing circuit based on an  LM339 quad comparator. Cost of the chip
30 cents :) It does not care about the amplitude. It will tolerate
voltages up to 36 volts.

Here is a better schematic.

I am starting over on the wiring. Mike used non color coded wire and
it is a bear to trouble shoot.

Paul Lamar




Hi Paul

If your wondering if the processors are working on the EC2, use the test modes.


1. With the Mode switch in Mode 0, press the Store switch (Primer function) and listen for the click of the injectors.  If they click, you at least know that the EC2 is getting power and is waiting for the crank sensor signal to start operating.

2. Put the Mode switch in Mode 1, turn the cold start switch on and press the Store switch.  This puts the EC2 in injector diagnostic mode.   All the injectors should now be continuously firing as if the engine were running at around 3000 RPM and should be easily heard. To end this diagnostic mode, change the Mode switch selection or cycle the power off on the EC2.

3. Put the Mode switch in Mode 8 and press the Store switch.  This puts the EC2 in ignition diagnostic mode and fires all the coils as if the engine were running at about 3000 RPM.  You should see all plugs firing.  To end this diagnostic mode, change the Mode switch selection or cycle the power off on the EC2.

Cheers


Steve Izett

-- 

Thanks Steve.
I guess it would help if I read the manual (again) :)
It has been several years :)

Paul Lamar.

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.