Subject: high speed CD ignition with air injection.
From: rotaryeng
Date: 6/14/2014, 9:17 AM
To: AAA-rotaryeng


If you firing a rotary engine six times every 10 degrees at 10,000
RPM you need a fast crank angle sensor.

It has the promise of reducing the fuel consumption, increasing the
power, reducing hydro carbon emissions and curing an occasional
mis-fire at idle due to port overlap. It is six times more likely to
fire a bad mixture.


Paul Lamar

Ignition of gasoline depends on the spark being immersed in a mixture
in the air fuel range of 10:1 to 20:1. The mixture ratio varies
widely in the combustion chamber and it is very turbulent meaning
that any given moment the mixture may or may not not be ignitable.
Due to port overlap some exhaust gases (less oxygen) could be
included making the mixture non ignitable at a given moment in time.

That is what happens in the old Mazda 13B and causes a distinctive
and noticeable miss at idle. The RX8 eliminated the port overlap for
that reason.

This ignition is six times more likely to find an ignitable mixture
ratio because it waits for a good mixture to come along :) Notice the
Wankel combustion stroke lasts almost 300 degrees while the piston
combustion stroke is only about 120 degrees. During this long time
period some un-combusted combustible mixture may be passing the spark
plug.

We know this to be a fact because of the high hydro carbon content in
the Wankel exhaust. Our goal is to ignite that mixture thereby
gaining a lower BSFC number and more power.


Paul Lamar

I just had another idea along these lines. If the mixture is too rich
to ignite a very small quantity of high pressure fresh air injected
close to the spark around TDC would help. The amount and duration
could be determined by experiment. Here are some 3D's. NOS or
hydrogen  could also be used but air is cheaper :)

Paul Lamar

A very good idea, this new approach to Stratified Charge RCEs! Now
that electronics, EFI and electromechanical devices have prices
lower that going out for dinner, the number of ways for improving
all issues formerly problematic in Wankel engines grows
exponentially year after year. Please keep us aware of results!

Best regards. Salut †         Jose Gros-Aymerich; Madrid,Spain

Hi, the Orbital Fuel injection uses dual injectors: one to meter the
fuel and another for the compressed air blast to inject it into the
cylinder. Mercury Optimax outboards are one application.  Originally
designed for two strokes, it works great on four strokes. I do not
know if it has been tried on a rotary.  It should work. They seem to
like to have the spark plug electrodes out in the edges of the
fuel/air plume.  That could be a problem with the rotary.  It is
more expensive than single fluid injection.


Murry I. Rozansky

The difference is the quantity of high pressure air. Small quantity
low compressor HP consumption. We need just enough to ignite the rich
mixture around the spark gap only.

Paul Lamar

       I consulted long ago with D W Garside the possibility of using
    the low-pressure Sarich Orbital direct injection, then under study
   by Ford in a 2-Stroke engine aimed at cars, but he told me they were
    testing a high pressure direct injection system in their Wankel RCEs.
      I don't know more. Thanks   Salut +
                           Jose Gros-Aymerich; Madrid, Spain

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.