Hallo: by serendipity, 'chiripa' in Spanish, I've found these comments
by one of the engineers who were involved in the development of OMC
Wankel engines.
Hope it's of some interest to you. Have a good season. Best regards.
Salut Jose Gros-Aymerich; Madrid, Spain
http://vintageomc.webs.com/theomcproduction.htm
"Max Bentle of Curtis Wright is credited with the kinematic inversion of
the engine allowing the housing to remain stationary with a rotating
crankshaft."
Untrue. It was a person at NSU. The name later.
"The pressurized oil system allowed the use of conventional babit
bearings and with the addition of an oil cooler to maintained internal
temperatures adequately."
Are you listening you Wankel heads in Europe? :)
"Curtis had use “D-Gun” tungsten carbide from Linde as their coating,
which was very effective, but extremely expensive."
Interesting.
"It was also hundreds of pounds lighter than the V-8 being used and as
such would out accelerate them even with 100 less hp."
"Both versions meet the design requirement of 100 hrs @ WOT."
"The trochoid coating was still “D-Gun”, as research hadn’t developed a
lower cost suitable coating yet."
"After several months of work, it became apparent an oil-cooled engine
could not be made cost competitive with a 2 cycle and work on oil cooled
engines stopped."
" Unlike a piston engine, the rotor is a captive heat source with very
little heat rejected to the housing walls. As such most of the cooling
had to come from the incoming charge to cool the rotor. The result is a
significant reduction in volumetric efficiency, the actual amount of air
going thru the engine vs its theoretical capacity. This is due to the
significant heating of the charge as it passes thru the engine."
"Unfortunately he had designed a 2 stage axial blower running at 30,000
RPM and took 35 hp to drive to cool the CW design."
"We knew an axial fan could not generate sufficient pressure that would
result in the velocity required to cool the engine."
"The rotor bearing was the weak link of this engine. Being inside the
rotor, it is completely dependent on the incoming charge for cooling and
lubrication. The bearing was already pretty special. It had a silver
plated retainer and a high temperature temper of the outer race. Steel
grows; get larger, as it gets hotter. That is until it exceeds the
temper temperature where in it gets smaller. As I figured out after
100’s of tests, there was a lubrication breakdown between the retainer
and the outer race. The result was steel running on steel at very high
speeds generating extreme heat. The result was the bearing shrinking
onto the crank eccentric stalling the engine. It took a hydraulic press
or a sledge hammer' to get them apart. I took several samples to SKF
Research and talked to the chief metallurgist. He told me this was
impossible to do. When I suggested he come to Waukegan and see for
himself, he said the bearing had to be reaching 1800 F for this to
happen. This type failure was self-destructing. When the bearing got
near its thermal breakdown temperature it would self generate additional
heat causing further oil breakdown, causing additional heat, etc, etc,etc. "
The European Wankel builders have yet to learn a lot of these lessons.
Not Mazda. Mazda is the gold of the Wankel world.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.