Subject: Best Tracy schematic
From: rotaryeng
Date: 6/16/2014, 1:47 PM
To: AA-1-Me



I notice that Tracy uses a separate ground for the injectors.
He is not fooling. If you connect the battery ground to the
injector ground it wont work. He should have mentioned
that. It is an attempt to keep the injector spikes out
of the computer. IMHO a few chokes here and there would also
have worked without the uncertainties :)


Paul Lamar

Not necessarily -- putting the currents where you want them, where they
don't share common impedance paths, is a better approach. "Chokes here
and there" doesn't work very well unless you have a lot of energy
storage in the power supply so it never sees the spikes anyway.
Otherwise you will always be fighting the voltage spikes on the computer
power that follow the current spikes from the injectors. Strongly
recommend Henry Ott's book "Electromagnetic Compatibility Engineering."
It's mostly about meeting EMC requirements but the issues are the same.
His earlier version "Noise Reduction Techniques in Electronic Systems"
is just as good for this problem.

David Josephson


True capacitors are needed. A 1000 Uf and a small choke on each injector
would work well I suspect. Worth a try.  Of course the computer well grounded
to the engine. Even better is mount the switching transistor on the injector
like a smart coil.


Thanks for the book tip. I'll get it.

Paul Lamar
-- 


   The Rotary Engine News Letter. Powered by Linux.
   ACRE NL web site. http://www.rotaryeng.net
   You Tube http://tinyurl.com/beqqxas
   Copyright 1998-2014 All world wide rights reserved.