Subject: Coax muffler sound. With MP4
From: rotaryeng
Date: 6/23/2014, 5:18 PM
To: AA-1-Me

Now that we have the sound of Neal's muffler documented we can
compare it with the coax muffler sound of Brian Trubee' RV4
muffler.

As you can tell the coax tone is lower and more IMHO pleasing :).


It is also a combined muffler and thrust augmenter.

One pound of thrust at 200 mph or 300 feet per second

is 300 lb ft/second.


The /mechanical horsepower/ of exactly 550 foot-pounds per second
is one HP.

Since thrust HP is net HP you don't have all the losses in the gear
box and prop. My guess that amounts to 80%. So one pound of thrust
becomes 300/.8 or 375 lb ft/second.

Now we still don't know how much thrust the coax muffler provides
so if Neal measured the top speed with his current muffler and then
installed a coax muffler we would find out :)

BTW equivalent flat plate area (EFPA) for a Van RV6 is about 2.32
square feet.

EFPA is equal to the drag factor times the frontal area.

The RV4 is about the same as the RV6.

Drag is equal to EFPA X .0026 X MPH^2 So RV4 drag at 200 MPH is
about 240 pounds. Net HP is 72000/550 or 131 NET HP out of the prop
or about 164 engine HP.

Brian is reporting good numbers with the coax but so far not back
to back with a good conventional muffler. His old muffler was
partially melted inside. A common occurrence with rotary muffler.
They must be inspected with a bore scope from time to time. On the
other hand a visual inspection of the open coax is all that is
needed.

Paul Lamar

Can I ask you to try something?  Cap off the down stream end of the
larger diameter tube, so that the gas must flow in the opposite
direction of the flow in the smaller tube.  The hot gas will then
exit the outside tube at the same end where the gas enters in the
smaller tube.  Why do this?  Because I did the same thing on on a
lawn mower muffler as I just described and I completely eliminated
the exhaust sound.  How does it work?  Imagine a sound wave traveling
through the smaller tube.  As it progresses past the small holes, a
small portion of the wave vents through the small holes and reverses
direction to exit the larger tube.  By the time the initial wave has
reached the far end of the small tube, that single wave has been
sliced up into several small waves that are exiting the large tube
over an extended period of time, not all at once as it would be if
they had not reversed direction in the larger tube.  Think of is as a
formation of planes flying on a down wind leg, each one peeling off a
few seconds apart from one another, causing a separation between them
for final approach.

This is my plan for quieting rotary on my plane.

Gary Schwarz


There goes the thrust if any. I don't recommend it as it becomes
un-inspectable.

It belongs to Brian Trubee anyway.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.