Here it is Mike Collier as promised.
The dimensions are critical to stuff everything into
the rubber bushing bracket.
I like the socket head 1/2 bolt as it is easy to use
and an Allen wrench will hold it when tightening the nut on top.
Things must be done in order. The 1/2 inch bolt goes first.
Then the upper link and rod end. When the engine is in proper
position for thrust line then trim the lower square tube
length and drill it for the 1/4 inch hole.
Install the 5/16 bolt before installing the lower square
tube. Drill a large hole in the front of the bracket so
a modified Allen head 5/16 wrench can be used to hold it.
The dwg shows a 5/16 hex head bolt. Use an Allen here
as well.
When everything is installed then drill the rear 1/4 inch bolt hole
through the bracket walls and the square tube.
Install the 1/4 inch bolt and tighten.
The essential function of the rear 1/4 inch bolt is the keep the
rubber bushing bracket vertical.
It is important to use AN bolts of the correct length. One does
not wanted bolt threads bearing on sheet metal.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.