Subject: EFI Ignition redundancy.
From: rotaryeng
Date: 6/27/2014, 3:11 PM
To: AA-1-Me


Paul,  The stats apparently point [out]  that most engine failures
are from electronic ignition. Need a fail proof system.

Neil.


When I first set out to design a stand alone ignition system I was
going to use one high voltage power supply and separate, simple
capacitor discharged systems for each plug.  If the HV supply failed
the engine would stop.

It turned out differently for reasons I can't go into now but the
current device is designed as one complete ignition system per spark
plug. Much like the now universally used coil on plug automotive
ignition systems.

It is ideal for a rotary aircraft engine as there are only 4 spark
plugs for 250 HP. A  four cycle, four cylinder  200 HP aircraft
engine has eight spark plugs so the current Lamar Instruments system
becomes impractical in that mode.

If any one Lamar Instruments ignition system fails the rotary keeps
running with reduced power. If one trigger fails the engine keeps
running on the other rotor.

With the current EFI if the CAS or the  computer  or the igniter box
fails the engine stops.

I have now cut the size and weight of the Lamar Instruments ignition.
Very important for one systems per plug.  The new size is 2 wide by 3
long and 2.75" high. The weight is also cut. The  old size was 3 by 3
by 3.

Paul Lamar --

Will there be a KOP/Hardware/diagrams/instructions for the 2 rotor
and 3 rotor engines? I'm interested? Marc

Yes. Marc the 3 rotor will require 3 triggers. One for each rotor.

Paul Lamar

Paul,
Are you far enough along to predict when your ignition system will be available for purchase?  Estimated $ for a 2 rotor and 3 rotor?

Don

As soon as the Lamar Instruments corporation is approved.
We await the California government on this matter. My accountant guesses
two weeks but it could take longer.

I got a legal education in these matters as my ex wife was secretary
treasurer of Litton Industries. I married her as soon as she graduated
from law school.

I am making systems as fast as can for testing. Chev V8 soon with
modified Chev distributor and an RX7 racer at Sebring July 19th.

I have not heard back lately from AIXRO but they have higher
priorities. I am sure I will learn a few things when I get
some actual test results.

I am running systems in the lab at 8 sparks at 11,000  RPM
continuously. Current drain at this level is .58 amps.

The metal box gets up to body temperature on a 80 degree day :)


Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.