Subject: making molds?
From: rotaryeng
Date: 6/28/2014, 4:52 PM
To: AAA-rotaryeng



Question:
I have a royalite/plastic (not fiberglass) part(s) that I want to make a reverse mold of so that I can lay up a new real fiberglass/CF part from it, with a few mods to it along the way.
What is the best way/process to do this (ie easy, fast and cheap!)? Fill the part with pour foam? Or some sort of fast rubber plug making concoction-I have seen such, but don't know what it is (I want to make more than one part from this 'plug')? Plaster of paris? (nah, done that before).
What considerations do I have here? Mold release? Etc.
Thanks for any advice!
Marc

Sounds like a Cessna interior trim or exterior fairing :)

Fill the back side with concrete and make a fiberglass
female mold of the front side.

I made a mold one time of the front wheel faring.

Saran Wrap makes a good mold release.
The surf board shops use liquid PVC.
You spray it on and it is water soluble when it comes
time to separate the part from the mold.

You can also get thin sheet rubber at McMaster Carr.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.