Subject: Installing ignition on RX7 race car
From: rotaryeng
Date: 7/16/2014, 4:11 PM
To: AA-1-Me



Paul, never mind the installation manual, how did the race go??? Tell
dady now with a few figures!

Neil.


Has not run yet. Hopefully we will get it running today.

Then it is off to the chassis dyno for a few pulls.

Sebring is not until Saturday.

Paul Lamar

Good luck, Paul.

Murry I. Rozansky


I screwed up big time today and wired the 12 volt supply to the output
wire on the optical pick up. The engine would not start of course.

I thought I blew both optical pickups.  I did not bring any spares so
it looked like I was all through for this test. Then I also noticed I failed
to connect the ground wires. I made a mistake on the mistake :)
A double mistake of this kind means no mistake at all. Two negatives
make a positive. I did not destroy the pickup after all. It still worked.
Dave and I were  working in 90F heat at 100% humidity.  A thunder storm
came through about 2 PM. Plus some neighbors got wind of what
was going on and came over to ask a lot questions.

I''l try again tomorrow morning. When I am rested  and it is a bit
cooler.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.