Subject: SEBRING RESULTS - SO WHAT HAPPENED
From: rotaryeng
Date: 8/5/2014, 6:30 AM
To: AA-1-Me


We encountered a rare and strange phenomena. When you have an amount
of unlimited current from a car batterycertain MOSFETs can some times
fail.

This has happened to me twice. Once when I bought an off the self
switching supply from Linear Tech and then again in Florida.

Most R&D is done with lab supplies that have some output limits on
current so this does not show up.

Surprisingly as little as ten ohms in series with the battery
prevents thisphenomena.

BTW one can tig weld with as little as 3 car batteries in series. All
you need is a tig torch and a tank of argon. Saves about a $1000 for
a real tig welder.

We will try again Aug 9th.

Paul Lamar
      Hi!: the idea of inserting a 10 Ohm resistor in series with battery
    cable is interesting, I had some Electronic Ignition failures that look
   related to the phenomenon described, however: what kind of a
   10 Ohm resistor? Where can I find this? Would the resistance become
   hot as Amps start going through it, and will this increase load to
   battery, thus making for the battery easier to be exhausted?
     What's exactly the way of installing the resistor? Is there
   somebody able to send a photo as example?
         Thanks for your kind attention, have a good season.
       Best regards. Salud †
                Jose Gros-Aymerich
              Madrid, Spain

 Not recommended for conventional ignitions.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.