Hey All,
I just found out about a nice PC Board layout program. Check this
out.
http://www.kicad-pcb.org/display/KICAD/KiCad+EDA+Software+Suite
Mark LaPierre
What PC Board makers accept the files?
I am using ExpressPCB right at the moment. Free windows layout
software.
Three 2.5" x 3.8" double side plated hole boards for $51 US.
Paul Lamar
I don't know about getting the files sent to a manufacturer, but the
file formats supported are listed on this page.
http://www.kicad-pcb.org/display/KICAD/File+Formats
Mark LaPierre
.brd PCB layout file
I have never heard of this format. With out a list of board makers
that accept this file formate what am I supposed to do. Poll the
board makers and see who accepts this format?
.brd PCB layout file
I would really like a Linux PCB layout program.
Paul Lamar
The universal format everyone accepts is RS-274X photoplotter files
(Gerber extended format) and Excellon NC drill files. Anything else
is something proprietary tied to a board house or other vendor. For
10 years I used OrCAD, and then switched to Eagle from Cadsoft about
10 years ago. I have version 5.6 and it's plenty. Newer versions run
on Windows, Mac or Linux. The free "light" version makes double
sided, 100x160 mm boards and only one schematic sheet. There's a
learning curve but mostly it just works. There is a huge worldwide
user community that has answered any question I ever came up with.
For prototype pcbs I use Advanced
www.4pcb.com which has cheap
"barebones" service that's comparable to ExpressPCB.
David Josephson
Thank you very much David. I'll get a quote on my boards from
Advanced
www.4pcb.com
Paul Lamar
It would appear that Kicad generates Gerber files. See the attached
pdf. Until David mentioned (Gerber extended format) I didn't know what
to look for. I hope the pdf comes through.
- Mark LaPierre
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.