Subject: Measuring the fuel consumption with the new ignition
From: rotaryeng
Date: 8/11/2014, 2:54 PM
To: AA-1-Me


   I came up with a plan onmeasuring the fuel consumption with the new ignition
   using the RX8. The idea is to take the ignition trigger out
   of the RX8 computer and transform it to fire the plugs six times
   instead of only once. Then replacing the Kettering smart coils
   with four of my ignitions.

   This is a daunting chore if done over a wide range of RPM's but
   rather simple if only one RPM is involved.

   4000 RPM in top gear is 80 MPH so I chose that RPM.
   This will use the recorded  OBD II combustion air flow data
   to calculatethe fuel burn with one spark and six sparks.

   See the attached  OBD data jpg.

   The idea is to use 4 double pole double throw relays to select
   one spark or six sparks while the engine is running.
   This way the engine can be started on one spark and
   accelerated up to 4000 RPM and 80 MPH on a flatroad.

   Then six sparks are selected with the relays and data is recorded.
   Back to back tests under the same atmospheric conditions,
   the same RPM and the same engine load can be made every
   few minutes to detect small changes in fuel consumption.

   The attached schematic is for one ignition and one plug.
   This will be reproduced for 4 spark plugs.

   Please upload your comments and any better ideas.

   Paul Lamar



I hope you have access to an old airfield or something (maybe the ones that the Myth-busters use). I routinely monitor my fuel consumption at the g/hr rate on the interstate and I find it challenging to maintain any sort of constant burn rate. Any change in speed is going to cause your measurement to be invalid unless you can duplicate the same event during the base test..
What about an hour of dyno time at a local tuner shop?

Daniel Tyler


We have this 300 mile long highway here in California Route 5 when at certain
times of the night and on certain days there is very little traffic. Dead flat
and dead straight.

Also the beauty of OBD  II it only takes about a minute to get a good sample
of fuel burn.  The raw  data is updated about every two seconds and the sensors
are superb. It does not use fuel flow sensors which are historically unreliable.
It uses the mass air flow sensor and then injects the amount of fuel needed.
The computer knows how much fuel is being injected as it reads the O2 sensors
to verify the mixture ratio.

Chassis dyno's are not accurate (OK for HP) and engine dyno's are $600 a day and up.
Mostly up.


Paul Lamar


   The Rotary Engine News Letter. Powered by Linux.
    ACRE NL web site. http://www.rotaryeng.net
    You Tube http://tinyurl.com/beqqxas
    Copyright 1998-2014 All world wide rights reserved.