Subject: Measuring the fuel consumption with the new ignition
From: rotaryeng
Date: 8/13/2014, 10:15 AM
To: AA-1-Me



    I came up with a plan onmeasuring the fuel consumption with the new
ignition
    using the RX8. The idea is to take the ignition trigger out
    of the RX8 computer and transform it to fire the plugs six times
    instead of only once. Then replacing the Kettering smart coils
    with four of my ignitions.

    This is a daunting chore if done over a wide range of RPM's but
    rather simple if only one RPM is involved.

    4000 RPM in top gear is 80 MPH so I chose that RPM.
    This will use the recorded  OBD II combustion air flow data
    to calculatethe fuel burn with one spark and six sparks.

    See the attached  OBD data jpg.

    The idea is to use 4 double pole double throw relays to select
    one spark or six sparks while the engine is running.
    This way the engine can be started on one spark and
    accelerated up to 4000 RPM and 80 MPH on a flatroad.

    Then six sparks are selected with the relays and data is recorded.
    Back to back tests under the same atmospheric conditions,
    the same RPM and the same engine load can be made every
    few minutes to detect small changes in fuel consumption.

    The attached schematic is for one ignition and one plug.
    This will be reproduced for 4 spark plugs.

    Please upload your comments and any better ideas.

    Paul Lamar



I hope you have access to an old airfield or something (maybe the ones
that the Myth-busters use). I routinely monitor my fuel consumption at
the g/hr rate on the interstate and I find it challenging to maintain
any sort of constant burn rate. Any change in speed is going to cause
your measurement to be invalid unless you can duplicate the same event
during the base test..
What about an hour of dyno time at a local tuner shop?

Daniel Tyler


We have this 300 mile long highway here in California Route 5 when at
certain
times of the night and on certain days there is very little traffic.
Dead flat
and dead straight.

Also the beauty of OBD  II it only takes about a minute to get a good sample
of fuel burn.  The raw  data is updated about every two seconds and the
sensors
are superb. It does not use fuel flow sensors which are historically
unreliable.
It uses the mass air flow sensor and then injects the amount of fuel needed.
The computer knows how much fuel is being injected as it reads the O2
sensors
to verify the mixture ratio.

Chassis dyno's are not accurate (OK for HP) and engine dyno's are $600 a
day and up.
Mostly up.


Paul Lamar


I check highest speed with 20% injector duty cycle when searching for
best afr/mph and best advance.
Compare the old ignition and the new system.
Barry Bordes

I can't do that with out building a HV switch that will switch coils.

Too much work.

Here is what the PCB and relay looks like for one ignition and one spark

plug.

Paul Lamar

An OBD II reader would give you the Injector Duty info on your RX8.

Barry Bordes

Interesting but not enough info. The amount of air pumped and processed
at a given mixture ratio is a direct read out of the fuel burned.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2014 All world wide rights reserved.