Subject: Cutting narrow strips of metal on a sheet metal shear.
From: rotaryeng
Date: 8/20/2014, 4:38 PM
To: AA-1-Me

I needed some narrow strips of metal
and shear blades are at least 1/8th inch wide.
I got this ridicules  quote for narrow sheet metal strips.

-----------------------------------------------------------------------------
Quote:
Good Afternoon Paul,

We do not have that part in stock. Our minimum order is 5,000 pieces at $160.00 per thousand. Since the part is not in stock there also is a setup charge of $300.00.

Regards,
Bob Halkowicz
National Sales Manager

Bead Electronics
A Div. of Bead Industries, Inc.
11 Cascade Blvd | Milford | CT | 06460

office. 203.301.0270 x 15
cell. 203.278.4321
fax. 203.301.0280

-----------------------------------------------------------------------------
Total  cost $1100. The material needed cost less than $50.
I only wanted a 1000.

Also if you order material from On Line Metals
they can't cut anything less than an 1/8th
of an inch wide.

That is because of the design of the back gages that interfere with
the cutting blade.

Here is a front gage trick that works accurate to .001 inches.

The threaded rod is 10-32.  Twist the rods to set the width.

The bar holding the dial indicators is C clamped to
the front extension table of the shear.

Took me about 2 hours to make this.
Could easily be automated with stepper motors.

Patent pending :)

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2014 All world wide rights reserved.