Subject: Cutting narrow strips of metal on a sheet metal shear.
From: rotaryeng
Date: 8/21/2014, 2:45 AM
To: AAA-rotaryeng


I needed some narrow strips of metal and shear blades are at least
1/8th inch wide. I got this ridicules  quote for narrow sheet metal
strips.


----------------------------------------------------------------------------
-

Quote: Good Afternoon Paul,

We do not have that part in stock. Our minimum order is 5,000 pieces
at $160.00 per thousand. Since the part is not in stock there also
is a setup charge of $300.00.

Regards, Bob Halkowicz National Sales Manager

Bead Electronics A Div. of Bead Industries, Inc. 11 Cascade Blvd |
Milford | CT | 06460

office. 203.301.0270 x 15 cell. 203.278.4321 fax. 203.301.0280


----------------------------------------------------------------------------
-

Total  cost $1100. The material needed cost less than $50. I only
wanted a 1000.

Also if you order material from On Line Metals they can't cut
anything less than an 1/8th of an inch wide.

That is because of the design of the back gages that interfere with
the cutting blade.

Here is a front gage trick that works accurate to .001 inches.

The threaded rod is 10-32.  Twist the rods to set the width.

The bar holding the dial indicators is C clamped to the front
extension table of the shear.

Took me about 2 hours to make this. Could easily be automated with
stepper motors.

Patent pending :)

Paul Lamar



What are the specifications for these strips?

Material: Width: Thickness: Length:

Tolerances:

Mark LaPierre


There for a secret project. If I told you I would have to ........
:)

Paul Lamar

Hi Paul, What material?  water jet cutting will do almost everything.

Photochemical machining is good for thin materials that could be waterjet
damaged.


Murry I. Rozansky

In my experience water jet cutting is much slower than shearing
and therefor would be too expensive. Last time I had something
water jet cut it cost a bunch. The finish on the edges is not
all that great.

It has been years since I had anything photochemical machined
so I have no idea what that would cost. Might be competitive.

Laser cutting is costly too as the very expensive machine must
be paid for.

One can buy a manual, sheet metal, small shear, for as little as $160.
Industrial Metals Supply in Burbank sells them.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.