Subject: Cutting narrow strips of metal on a sheet metal shear.
From: rotaryeng
Date: 8/21/2014, 7:51 PM
To: AA-1-Me



I needed some narrow strips of metal and shear blades are at least
1/8th inch wide. I got this ridicules  quote for narrow sheet
metal strips.

-----------------------------------------------------------------------------



Quote: Good Afternoon Paul,

We do not have that part in stock. Our minimum order is 5,000
pieces at $160.00 per thousand. Since the part is not in stock
there also is a setup charge of $300.00.

Regards, Bob Halkowicz National Sales Manager

Bead Electronics A Div. of Bead Industries, Inc. 11 Cascade Blvd |
Milford | CT | 06460

office. 203.301.0270 x 15 cell. 203.278.4321 fax. 203.301.0280

-----------------------------------------------------------------------------



Total  cost $1100. The material needed cost less than $50. I only
wanted a 1000.

Also if you order material from On Line Metals they can't cut
anything less than an 1/8th of an inch wide.

That is because of the design of the back gages that interfere
with the cutting blade.

Here is a front gage trick that works accurate to .001 inches.

The threaded rod is 10-32.  Twist the rods to set the width.

The bar holding the dial indicators is C clamped to the front
extension table of the shear.

Took me about 2 hours to make this. Could easily be automated with
stepper motors.

Patent pending :)

Paul Lamar



What are the specifications for these strips?

Material: Width: Thickness: Length:

Tolerances:

Mark LaPierre


There for a secret project. If I told you I would have to ........
:)

Paul Lamar



Check for a shop that does slitting.

Gary Knutson


Good Idea Garry. Thanks.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.