Subject: Cutting narrow strips of metal on a sheet metal shear.
From: rotaryeng
Date: 8/23/2014, 5:58 PM
To: AA-1-Me



I needed some narrow strips of metal and shear blades are at least
1/8th inch wide. I got this ridicules  quote for narrow sheet
metal strips.

-----------------------------------------------------------------------------



Quote: Good Afternoon Paul,

We do not have that part in stock. Our minimum order is 5,000
pieces at $160.00 per thousand. Since the part is not in stock
there also is a setup charge of $300.00.

Regards, Bob Halkowicz National Sales Manager

Bead Electronics A Div. of Bead Industries, Inc. 11 Cascade Blvd |
Milford | CT | 06460

office. 203.301.0270 x 15 cell. 203.278.4321 fax. 203.301.0280

-----------------------------------------------------------------------------



Total  cost $1100. The material needed cost less than $50. I only
wanted a 1000.

Also if you order material from On Line Metals they can't cut
anything less than an 1/8th of an inch wide.

That is because of the design of the back gages that interfere
with the cutting blade.

Here is a front gage trick that works accurate to .001 inches.

The threaded rod is 10-32.  Twist the rods to set the width.

The bar holding the dial indicators is C clamped to the front
extension table of the shear.

Took me about 2 hours to make this. Could easily be automated with
stepper motors.

Patent pending :)

Paul Lamar



What are the specifications for these strips?

Material: Width: Thickness: Length:

Tolerances:

Mark LaPierre


There for a secret project. If I told you I would have to ........
:)

Paul Lamar



Check for a shop that does slitting.

Gary Knutson


Good Idea Garry. Thanks.

Paul Lamar


That was the hot tip Gary. Perfect!  Dead nuts on. Thanks.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.