Hello Neil,

See attached as requested.

Also link to YouTube video: http://youtu.be/N2P5tHB5s3s

LinkedIn icon <https://www.linkedin.com/company/maspro-engineering>

Paul,    U tube and cross section.  The input shaft shows the spline
incorrectly at the bottom.  Details,   Neil.


I don't see a thrust bearing for the helical sun gear.

Paul Lamar

Paul,  Good point, it is supposed to be there, Will check.

Neil.

It is going to take a lot of time for the NC mill to contour that
billet housing to get the weight out. Read money :)
The price of this thing might be beyond what people
can afford :) It may be better to make a pattern on the
NC mill and have it cast.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.