Subject: Ignition installation on RX7 racer.
From: rotaryeng
Date: 9/11/2014, 4:37 AM
To: AA-1-Me



Hopefully it will run after Dave gets it wired up.

Paul Lamar

------------------------------------------------------

BTW the support bracket for the ignition systems  was made out
of 1" X 1" X 1/8th inch aluminum angle obtained at
Home Depot. Same for the 1" X 1/8th inch bracing straps.

It was quite rigid.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2014 All world wide rights reserved.