Subject: NEW GEARBOX REDUCTION IDEA Visit with Jean
From: rotaryeng
Date: 9/14/2014, 6:27 PM
To: AA-1-Me





Paul As per today all major cars are built with front drive and almost built with a wheel bearing hub integrated with double ball bearing who act as trust in both sides and as been proof since lot of years..

I found one who can be use to match the prop stubs by machining those hole stubs between the original wheel stubs and remove the existing stubs and enlarge them to remove excess weight'.

The wheel flange have to be reduce in diameter to standard prop shaft size flange.

The attaché triangular flange can be machined to .200" thickness to reduce weight and all these parts are soft enough to be machined.

The hub can be hold on pressure fit and with 3 long bolts from the inside aluminum casing and the head seal with orings to hold the oil pressure inside the gears chamber, or 3 long treaded studs.

The aluminum casing can be machined from solid bar or get it cast from foundry, it can also be added some ribs for more stiffeness

You can find the wheel hub bearing in Ebay at $40.00 and up depends on quality.

The both shaft are about $80.00 from Slauson Transmission Parts,all other parts as sun gear ,planet.ring gear,front ring,drum forward ,bearings less then $200 from Slauson few years ago

I am sending you several sketch showing how to built this gear box and it might be a few more pounds of Tracy one , much cheaper and fast to built with almost available parts.

JEAN PRUDHOMME

Jean also sent some picture of his rotary powered scale Piaggio Avanti he is working on. Perhaps by mistake :) Interesting nose gear.

BTW Jean set your epson scanner to save as jpg instead of pdf. Then you can attach the jpg's to email.

Paul Lamar


Paul


I just finish to extend my garage with a total length of 50 ft and all my tool are in place,i will have enough space to built the fuselage plug.
I am still building my original gearbox with internal passage for the constant speed and install a stator.
I came up with the hub idea for someone want to built his own cheap and fast to built.
I do have all steel and aluminum parts for the gear box Include the last 2 Velocity I built from Google.com and enter N274JP and clic Prudhomme



JEAN PRUDHOMME


We were in  south Florida so we visited Jean Prudhomme.

Jean is a very prolific and talented  aircraft builder. He has been working on airplanes since the late 60's. So far he as built nine. Many Velocities.

Here are some pictures of gear box parts he intends to use on his 3/4 scale Piaggio Avanti.

Paul Lamar


Jean,
I assume P-1160044 JPG is a photo of an auto transmission 7A and a reduction housing. We are interested in the reduction housing for a 3.i7 reduction housing. Do you have a dimensioned sketch of the reduction housing?  And can the housing be purchased separate before machining?

Milo

The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2014 All world wide rights reserved.