Subject: 81 to 85 distributor waste spark???
From: rotaryeng
Date: 12/5/2014, 6:09 AM
To: AA-1-Me



Anybody know for sure. ?

I think it is as there are only two coils.
One for leading and one for trailing coils.

There are four trigger tits and it rotates at half e-shaft
speed. There is a slight time delay between VR sensors.

I assume one sensor and igniter  is the trailing plugs and the second
is the leading plugs.

PaulLamar



No waste spark. Creative Japanese solution to put all the ignition in one distributor.
The center HT wire comes from one coil. The wire at the 11 o'clock position comes
from the other coil. The rotor has a straight through contact like the original two
distributor engines. The plug wire terminals for rotors 1 and 2 are 90 degrees apart
on the cap.

When #1 fires, the electrons flow through the rotor contact bar to the
end close to the #1 plug wire. When the engine rotates 180 degrees, the distributor
turns 90 degrees. Now the electrons flow to the other end of the rotor to the #2 plug
wire.

Now it gets interesting as the second coil and plugs need a different method to get
the electrons delivered to the correct plug. The rotor has two conductors that end
90 degrees apart. Now the #1 and #2 plug wires are 180 degrees apart. When the
coil fires the electrons arrive at the coil wire terminal. One of the conductors terminals
will be close to the terminal in the cap. Electrons are conducted through the conductor
to the plug terminal#1. The engine turns 180 degrees and the distributor 90. Now the
electrons flow through the conductor in the opposite direction to the #2 plug terminal.

The engine turns another 180 degrees, the distributor 90 degrees. Now the second
90 degree conductor in the rotor comes into play. It is now aligned between the coil
terminal and the #1 plug terminal. The rotor is a complex looking part but quite simple.

The pickups are one each for leading and trailing. As per Mazda a few degrees difference
between leading and trailing timing.


To simplify adjustment, make up two HT leads to go from the coils to the leading plugs.
The engine can now be run with the cap and rotor off the engine. Set the leading timing
as per specifications. The trailing pickup is then moved to set the trailing timing to
specs. Saves making small adjustments to the trailing and then putting the cap back
on and starting it again to check the timing again.

If you want to mess with a friends head, set the trailing to fire at the leading timing and
arrive at their garage. Pop the hood and let them scratch their noggins trying to figure
out how it runs without a cap and rotor.

Dale Davies


Very very interesting.  I had no idea the rotor & cap was designed to do all that.
Very clever.

Was this used on other cars not just on the RX7?

Thanks Dale. As usual you are well informed on engine tech.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2014 All world wide rights reserved.