Paul,
Just a bit of web searching has yielded a firm utilizing "SPARCS".
They also have invented an "Expander" with a claimed increase in
efficiency of 20%. It looks like they are working on a family of
engines, 5 to 120 hp.
Here is their website.
http://www.aieuk.com/Check out their video
and note the SPARC pressure. One of the pictures shows the
elliptical expander rotor. Perhaps on your next trip across the pond
you can stop in on them?
Advanced Innovative Engineering <
http://www.aieuk.com/ AIE was
formed with one goal, to be a world class engineering design,
development and production organisation Read More Make an enquiry
View on
www.aieuk.com <
http://www.aieuk.com/
My best, Anthony AKA John Smith :)
Very interesting. Due to the video of the test runs resulted in some
of the best Wankel engine documentation around. Too bad they did not
equip the test stand with torque sensors so HP could be recorded.
Also too bad no full RPM-full HP run's were shown. Max RPM shown was
5000. The BSFC is rather high at .57 when the Mazda will do .47. That
is 21% better.
I am rather surprised that there was enough blow by gases to be
cooled and then used to cool the rotor. Given the bit of smoke on
start up that indicates a side sealing problem. That would be
unacceptable in a production range extender. The pressurized cooling
system adds to the fuel burn.
The Europeans, and the Britts for that matter, really need to copy
the Mazda Wankel exactly and start from there.
BTW range extenders suck :) The GM Volt loses one mile of battery
charge for every mile driven at 80 MPH. Then it is a 4000 pound slug
with a 1.4 L engine. Then the battery must be recharged for 8 to 10
hours. It only starts with 30 miles. I personally tested it myself.
Range extenders might be OK for taxi's and milk delivery trucks :)
Also BTW I tried a dozen times to send them this email but the anti
spider device they had on the web site did not work. Would somebody
else try to send this email to them.
------------------------------------------------------- Here are some
screen captures.
Paul Lamar
Hi!: nice engine. A bit noisy? You speak about blow by gases, but:
What origin/source, what way, what path?
For those interested in small Wankel RCEs, I again strongly suggest
considering the purchase of SAE paper 2013-32-9161, on an air-cooled
UAV engine fitted with a heat pipe (Wei Wu et al, University of Florida)
and for everyone involved in Wankel tuning, the SAE paper 2013-32-9161,
(Dun-Zen Jeng et al, Taiwan), on the 'Intake and exhaust pipe effect
on Rotary
Engine performance'. The information in this paper may be known, but you
have it all collected into 9 pages, at $24 downloading one, it's not too
expensive.
If you purchase it, please let us know your opinion, and eventually, the
results achieved.
Thanks, nice weekend. Best regards. Salud
Jose Gros-Aymerich
The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net <
http://www.rotaryeng.net/You Tube
http://tinyurl.com/beqqxas Copyright 1998-2014 All world wide rights
reserved.