The article made is sound like Mistral made all the parts and nobody
else ever put a Mazda 3 rotor in an airplane before :)  Perhaps
Kitplanes is angling for a Mistral ad. Don't hold your breath
Kitplanes :)

I never saw a Mistral engine that did not have at least Mazda rotor
housing and may be all the other Mazda end and center housing are on
Paul Janssens's  engine. I have seen lots of Mistral engines in the
US and all over Europe in shows.

The rotor housing coatings are nearimpossible to coatfor that size
engine without the Mazda steel liner. I could be proven wrong but I
would have to see 2000 hours in aircraft service on a coated
housing.

The only part that cracked was the Mistral cast oil pan. There is
zero load on the Mazda oil pan unless somebody forgot to install the
large hollow dowel pins between all housings.

However Kitplanes is turning into a great experimental aircraft
magazine ten times better that that fluff job EAA Sport Aviation rag
:)

Here are some factory photos.

Paul Lamar


So is Mistral back in business?

Bill Jepson

As far as know they may still be in biz technically  but they are
definitely inactive.


How many people on here buy kitplanes magazine?

Paul Lamar


I do.

gary lucky



Me Too!!...........

Kelly Troyer

I subscribe, but seldom read all the articles.

Mark S.


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.