Subject: Long prop drive shaft.
From: rotaryeng
Date: 12/16/2014, 9:59 AM
To: AA-1-Me




Hi Paul. I am revisiting the long drive shaft for a pusher design.
With the progress made on composite drive shaft, is the option of
long and light prop shaft becoming more of a reality now? I saw a lot
of automotive carbon shafts on the market now for very decent prices.
Could a simpler design with rubber couplings instead of power/slip
clutch be made to work without outlandish development cost and
headache? I would appreciate your thought.
Luke F Wings.


How long?

I would use a minimum of 3.5 inch diameter aluminum tube.
Cut the wall thickness on a lathe to  .062" to save weight.
Then anodize it so epoxy will stick .
diagonally wrap carbon fiber to a total thickness of .125 to .2 inch.

If not too long get a stock  RX8 carbon drive shaft from a junk yard.
Yes rubber couplings are the way to go.

Paul Lamar

Will anodizing be as good as the process used on grumman GA?
THANKS.
L F WINGS.

I don't know what they used on that airplane. You can buy a kit in
West Marine to treat aluminum for epoxy bonding.

How long is the prop shaft?

Paul Lamar


I am looking at 48 inches or less. I also consider putting the shaft between gear drive and the engine. I thought this way I could use a smaller/lighter shaft and not having redundant bearings at the prop. Thought? ?
Thanks.
Luke WINGS.

That is the way they did it in the Bell P39. Draw back for a pusher is
potential CG problems and polar moment of inertia around a vertical axis
in a spin.


Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.