Subject: Long prop drive shaft.
From: rotaryeng
Date: 12/16/2014, 10:44 PM
To: AAA-rotaryeng



Hi Paul. I am revisiting the long drive shaft for a pusher design.
With the progress made on composite drive shaft, is the option of
long and light prop shaft becoming more of a reality now? I saw a
lot of automotive carbon shafts on the market now for very decent
prices. Could a simpler design with rubber couplings instead of
power/slip clutch be made to work without outlandish development cost
and headache? I would appreciate your thought. Luke F Wings.


How long?

I would use a minimum of 3.5 inch diameter aluminum tube. Cut the
wall thickness on a lathe to  .062" to save weight. Then anodize it
so epoxy will stick . diagonally wrap carbon fiber to a total
thickness of .125 to .2 inch.

If not too long get a stock  RX8 carbon drive shaft from a junk
yard. Yes rubber couplings are the way to go.

Paul Lamar

Will anodizing be as good as the process used on grumman GA? THANKS.
L F WINGS.

I don't know what they used on that airplane. You can buy a kit in
West Marine to treat aluminum for epoxy bonding.

How long is the prop shaft?

Paul Lamar

Isn't there a vibration issue with anodized parts. There was an award
winning Experimental helicopter where the builder had anodized a lot of
parts for a blingier look, including I think the drive shaft. After about 60
hours the blingy part failed catastrophically causing a complete wreck of the
machine. IIRC the anodizing process introduces microscopic stress risers.
Feel free to correct me if I've got this all buggered up.

John Gibbons


The aluminum tube is just a male mold for the carbon fiber.

BTW when you have a high modules of elasticity material (carbon) sharing the load
with a low modulus of elasticity material (aluminum)  the high modules material takes
most of the load.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.