Subject: Long prop drive shaft.
From: rotaryeng
Date: 12/16/2014, 10:59 PM
To: AAA-rotaryeng


Hi Paul. I am revisiting the long drive shaft for a pusher design.
With the progress made on composite drive shaft, is the option of
long and light prop shaft becoming more of a reality now? I saw a lot
of automotive carbon shafts on the market now for very decent prices.
Could a simpler design with rubber couplings instead of power/slip
clutch be made to work without outlandish development cost and
headache? I would appreciate your thought.
Luke F Wings.


How long?

I would use a minimum of 3.5 inch diameter aluminum tube.
Cut the wall thickness on a lathe to  .062" to save weight.
Then anodize it so epoxy will stick .
diagonally wrap carbon fiber to a total thickness of .125 to .2 inch.

If not too long get a stock  RX8 carbon drive shaft from a junk yard.
Yes rubber couplings are the way to go.

Paul Lamar

Will anodizing be as good as the process used on grumman GA?
THANKS.
L F WINGS.

I don't know what they used on that airplane. You can buy a kit in
West Marine to treat aluminum for epoxy bonding.

How long is the prop shaft?

Paul Lamar


I am looking at 48 inches or less. I also consider putting the shaft
between gear drive and the engine. I thought this way I could use a
smaller/lighter shaft and not having redundant bearings at the prop.
Thought? ?
Thanks.
Luke WINGS.

That is the way they did it in the Bell P39. Draw back for a pusher is
potential CG problems and polar moment of inertia around a vertical axis
in a spin.


Paul Lamar


As I remembered, the effect moment of inertia along the longitudinal axis tend promote flat spins. The examples are twins and Grumman AA-1x (fuel in outer wing tube spar. I own one). I totally forgot the effect of moment of inertia along the lateral do. I remember vaguely that it promotes steep and fast spin. Is that right? Please educate me on this one.
Anyway,  the Rohr 2-175 inspired me. I am aware of the aerodynamic handicap of a delta. However, I could probably build a strong and super light airframe with a powerful rotary. This will compensate for the delta disadvantages some what. I'll stay away from the ducted fan though. Thanks
Luke Wings.

You got me there.
I.E.The effect of moment of inertia along the lateral axis effect on spinning.
The ducked fan is inefficient in our speed range.

Paul Lamar


 The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2014 All world wide rights reserved.