I'm looking to get the p-porting rotor housings, sealing blocks and
PSRU adpater plates. If anyone else wants to do a parts order, please
reply back to this email and we'll get a list going for Jeff to setup
his machining.

-Matt

On 11/12/2014 5:15:44 AM, rotaryeng <rotaryeng@earthlink.net wrote:
Jeff can do the job on p-ports. He is already set up for it. Just
takes a few minutes on the NC mill.

Paul Lamar

I talked to Jeff and he is looking for a few people committed on
parts so it's feasible to setup the machining. Can we send out a
newsletter looking for people? I'd like to get my stuff done and I'm
good for p-ports and the adapter psru. I'm not sure what else he
machines vs what you have for sale.? -Matt Boiteau

Jeff does p-porting of rotor housings, sealing blocks and PSRU
adpater plates. I have parts for motor mounts, oil pans and torsional
couplings.

The economy has been so bad in the last six years that private
aviation has suffered greatly. Disposable income has disappeared and
gasoline prices have gone up needlessly. I firmly believe a possible
boom is on the horizon.

The key is getting rid of the last Democrat barrier in the 2016
elections. Allowing the keystone pipeline and cutting funds for the
EPA should be the first steps. US coal mining will increase as the
world wide demand for coal is unabated. Chinese goods must be taxed
until we have a balance of payments with China. Global warming was
and is a scam, pure and simple. Manufactured for political reasons.

Paul Lamar

Paul, any more people come forward looking for work to be done from Jeff?
Sent an email to Jeff but haven't heard anything back. Do you have any
contacts on the East cost that would do the CNC machining?

Reading on the Mazda rotary forums, a lot of the racers do a press fit
P-Port. A small coolant will leak at start-up and seal up once the engine
gets warm. None of them have heard of welding to the chrome.


I'm guessing around March is when the engine will be ready to mate with the
plane. I know we don't have a crystal ball, but should I look for RSW's
PSRU and ECM controller, or think the stuff in the works on here might be
able to test/use by then?


Matt Boiteau

That is strange. We have had 133.000 hits on  weld your p-port
video. That is an unprecendented  amount of hits for a u tube rotary video.


https://www.youtube.com/watch?v=NKJ00JsnS8A

Put NC machine shops in google

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2014 All world wide rights reserved.