This is a 2" by 6" aluminium extrusion about 4 inches long.
This is very similar to what I am doing with the ignition stuff
so I am all set up to machine the covers.

There is an aux board the same size as the MM board mounted below the MM.

So far there are two VR sensor circuits and eight high current drivers for
four coils and four injectors on the aux board. The next thing on the
aux board will be two
manifold pressure sensors. One for the front rotor and one for the
rear.

The back panel has the connectors for the VGA, the PC keyboard, the USB
connector and the 12 VOLT power connector.

The front panel will have two DB15's one for output and one for input.
Also a slot for the 65 gig SD card.

So far all through hole.
 -----------------------------------------------------

Here is my latest iteration of the PC board. I added an RS232 9 pin D-sub-min.
Matt Boiteau is using that.

The surface mount manifold pressure sensors are on the right,
29 psi so this board will work with turbo's.
I am thinking of adding  EGT sensor circuits.

EGT sensors respond slowly so It mind be possible adjust
 the mixture in cruise.

Of course they could be displayed on the EFIS part.

Anybody have any other things they would like added?

I should have this running on the RV4 in a few weeks.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.